Parked Regeneration Time Out (Dtc P3013 / 523590-16) - Kubota V3800-CR-TE4 Diagnosis Manual

V3800-CR-TE4,V3800-CR-TIE4, DM

(54) Parked Regeneration Time Out (DTC P3013 / 523590-16)

Behaviour during malfunction:
• None
Detection item:
• Time out error: regeneration imcomplete due to low temperature of DPF
DTC set preconditions:
• During parked active regeneration mode
DTC set parameter:
• Regeneration was not completed within target time (approximately 30 min.) when the state above continues for
2700 seconds or more
Engine warning light:
• ON
System action:
• None
Recovery from error:
• Diagnostic counter = zero (Leaving from parked active regeneration status)
1. Check the Installation of Exhaust Gas Temperature sensor
1. Check the installation of all exhaust gas temperature sensors
(T0, T1 and T2).
2. Check the installation condition of the thermostat, and whether
rust is not occurred.
3. Reinstall or replace the thermostat as necessary.
OK Go to "2. 2. DPF Manual Regeneration".
NG Repair or replace the exhaust gas temperature sensor or thermostat.
(Follow the diagnostic procedure of items P0543, P0546 and P242C)
(1) Exhaust Gas Temperature
Sensor T0
(2) Exhaust Gas Temperature
Sensor T1
(3) Exhaust Gas Temperature
Sensor T2
2. DPF Manual Regeneration
1. Place the key switch in the OFF position, and attach the
diagnosis tool to the CAN1 connector.
2. Turn the key switch to the ON position and select the "Exhaust
Gas Temperature Sensor 0", "Exhaust Gas Temperature
Sensor 1" and "Exhaust Gas Temperature Sensor 2" on the
data monitor function.
3. Perform the diagnosis tool active test ("DPF Manual
Regeneration").
Factory
No DTC is output.
specification
OK Normal.
NG Go to 3. Check the Exhaust Gas Temperature Sensors (Refer to items
P0543, P0546 and P242C)".
(a) CAN1 Connector
1-S273
COMMON RAIL SYSTEM
9Y1200192CRS0828US0
(A) Exhaust Inlet Side
(B) Exhaust Outlet Side
9Y1200192CRS0539US0
9Y1200192CRS0540US0
KiSC issued 05, 2012 A