Kubota V3800-CR-TE4 Diagnosis Manual page 286

V3800-CR-TE4,V3800-CR-TIE4, DM
2. Check the DTC
1. Place the key switch in the OFF position, and attach the
diagnosis tool to the CAN1 connector.
2. Turn the key switch to the ON position and select the "Exhaust
Gas Temperature sensor 0", "Exhaust gas temperature sensor
1" and "Exhaust gas temperature sensor 2" on the data monitor
function.
3. Check whether the DTC is output or not after starting up the
engine by monitoring the data signals.
Factory
No DTC is output.
specification
OK Normal.
NG Go to "3. Check the Exhaust Gas Temperature Sensor".
(a) CAN1 Connector
3. Check the Exhaust Gas Temperature Sensors
1. Check the exhaust gas temperature sensors (T0, T1 and T2).
OK Normal.
NG Repair or replace the exhaust gas temperature sensor or engine
combustion main parts. (Follow the diagnostic procedure of items P0543,
P0546 and P242C)
(1) Terminal A-GND3
(2) Terminal IDOC, ODOC or ODPF
1-S259
COMMON RAIL SYSTEM
9Y1200192CRS0506US0
(a) Exhaust Gas Temperature
Sesnsor (T0, T1 and T2)
9Y1200192CRS0507US0
KiSC issued 05, 2012 A