Kubota V3800-CR-TE4 Diagnosis Manual page 194

V3800-CR-TE4,V3800-CR-TIE4, DM
3. Replacing the ECU and Checking Whether the DTC Is
Detected Again
1. Replace the ECU.
2. Turn the key switch OFF and then ON again.
3. After clearing the DTC, turn the key switch OFF and then ON
again, and start the engine.
4. Check whether or not the same DTC (P0200) is detected.
Factory
DTC is not detected.
specification
OK ECU fault → Replace the ECU.
(a) CAN1 Connector
1-S167
COMMON RAIL SYSTEM
9Y1200192CRS0283US0
KiSC issued 05, 2012 A