Kubota V3800-CR-TE4 Diagnosis Manual page 209

V3800-CR-TE4,V3800-CR-TIE4, DM
9. Check NE Sensor Pull-up Resister
1. Remove the pull-up resister (1 kΩ) which is connected to
harness, then check next item.
• Check if there is improper connection of 1 kΩ resistive
element and connector.
• Check if there is damage of 1 kΩ resistive element.
(measure the resistance of resistive element with tester.)
OK Replace the ECU and test.
NG Replace 1 kΩ resistive element, or improve improper connection.
(1) Resister 1 kΩ 1/4 W
(2) Crankshaft Position Sensor
(3) Camshaft Position Sensor
1-S182
COMMON RAIL SYSTEM
(4) Rail Pressure Sensor
(5) Intake Air Temperature Sensor
9Y1200192CRS0315US0
KiSC issued 05, 2012 A