V3800-CR-TE4,V3800-CR-TIE4, DM
1. Checking Whether the DTC Is Detected Again
1. Turn the key switch OFF and then ON again.
2. After clearing the DTC, turn the key switch OFF and then ON
again, and start the engine.
3. Check whether or not the same DTC (P0611) is detected.
Factory
DTC is not detected.
specification
OK
It could be a temporary malfunction caused by obstructions to the radio
waves, so as long as it recovers to normal operation there is no problem.
NG
Go to "2. Replacing the Injector and Checking Whether the DTC Is
Detected Again".
(a) CAN1 Connector
2. Replacing the Injector and Checking Whether the DTC Is
Detected Again
1. Replace the injector.
2. Turn the key switch OFF and then ON again.
3. After clearing the DTC, turn the key switch OFF and then ON
again, and start the engine.
4. Check whether or not the same DTC (P0611) is detected.
Factory
DTC is not detected.
specification
OK
Injector fault → Replace the injector.
NG
Go to "3. Replacing the ECU and Checking Whether the DTC Is
Detected Again".
(a) CAN1 Connector
3. Replacing the ECU and Checking Whether the DTC Is
Detected Again
1. Replace the ECU.
2. Turn the key switch OFF and then ON again.
3. After clearing the DTC, turn the key switch OFF and then ON
again, and start the engine.
4. Check whether or not the same DTC (P0611) is detected.
Factory
DTC is not detected.
specification
OK
ECU fault → Replace the ECU.
(a) CAN1 Connector
1-S208
COMMON RAIL SYSTEM
9Y1200192CRS0374US0
9Y1200192CRS0375US0
9Y1200192CRS0376US0
KiSC issued 05, 2012 A