V3800-CR-TE4,V3800-CR-TIE4, DM
1. Start up a PC on which the diagnostic software has been
installed with administrator user account.
2. Connect the machine-side CAN1 connector (a) to the interface
connector (To Machine) (2) with the cable (To Machine) (1).
3. Connect the cable (USB) (4) to the USB connector (To PC) (3)
and then connect the USB cable to the USB port on PC.
4. Start the diagnostic software.
5. Select "Communication Setting" from "System Setting" in the
menu and execute. (Only when performing the initial settings.)
NOTE
• The USB port used while the "Communication Setting"
process, should always be used.
(1) Cable (To Machine)
(2) Interface Connector (To Machine)
(3) USB Connector (To PC)*
(4) Cable (USB)
* Rubber cap is attached to USB connector and DC jack each
1-S9
COMMON RAIL SYSTEM
(5) DC Jack (Reserved)*
(a) CAN1 Connector
9Y1200192CRS0012US0
KiSC issued 05, 2012 A