Excessive Pm3 (Dtc P3006 / 3701-15) - Kubota V3800-CR-TE4 Diagnosis Manual

V3800-CR-TE4,V3800-CR-TIE4, DM

(49) Excessive PM3 (DTC P3006 / 3701-15)

Behaviour during malfunction:
• Insufficient output
Detection item:
• PM accumulation level3
DTC set preconditions:
• Battery voltage is normal
DTC set parameter:
• PM accumulation more than trigger level (26000 mg)
Engine warning light:
• ON
System action:
• Output limitation: Approximately 50 % of normal condition
Recovery from error:
• Diagnostic counter = zero
1. DPF Manual Regeneration
1. Start DPF Manual Regeneration immediately.
NOTE
• This DTC means the warning to urge to start regeneration
rather than error. (Basically, Service Call is not necessary.)
• Followings are potential causes.
– A low load operation has been continuing.
– An engine is often left idling.
– A short time operation below 30 minutes has been
continuing.
(a) DPF Manual Regeneration
Reguest Button
1-S267
COMMON RAIL SYSTEM
9Y1200192CRS0823US0
9Y1200192CRS0525US0
KiSC issued 05, 2012 A