6. Select the Secondary EKM Server Settings (library-managed encryption only) —
7. Select the Encryption policy settings (library-managed encryption only).
8. Skip over the Advanced Encryption Settings. The purpose of these advanced
9. Click Submit to enable the settings.
Configuring E-mail Notifications
Figure 3-25. E-mail notifications
Note: This is an optional procedure.
To set up e-mail notifications of library events, complete the following procedure:
1. Expand Configure Library, if necessary, and click on Notifications in the left
3-24
TS2900 Tape Autoloader Setup, Operator, and Service Guide
• SSL port number — The port number of the primary encryption key manager
for SSL. The default port number is 443.
The address of the secondary encryption key manager on a server. IPv4 and IPv6
addresses are supported. Hostnames can be entered instead of numerical IP
addresses if the DNS server is specified.
• Address — The IP address of the secondary encryption key manager.
• TCP port number — The port number of the secondary encryption key
manager for TCP. The default port number is 3801.
• SSL port number — The port number of the secondary encryption key
manager for SSL. The default port number is 443.
• Encrypt All — All tape cartridges loaded into the tape drive are encrypted.
• Internal Label - Selective Encryption — This option is used only for
Symantec's Veritas NetBackup™.
• Internal Label - Encrypt All — This option is used only for Symantec's Veritas
NetBackup™.
encryption settings is to allow only IBM Support personnel (under the direction
of the drive development team) to provide a solution to an unforeseen problem
or to support a unique configuration. These options are not intended for use by
the customer without the guidance of IBM Technical Support.
navigation pane of the Web User Interface.