Removing Accessor Locking Screw - IBM TS2900 Setup, Operator, And Service Manual

4. Attach the deskside cover using the 2 large pan-head screws
Figure 8-10. Attaching the cover to the library chassis (rear screws)
5. Place the library in the desired desktop location.
Important: Do not place the library on its side. Do not stack objects on top of the
6. Remove the Accessor locking screw
Figure 8-11. Removing Accessor locking screw
7. On the rear panel of the library:
8. Insert the cartridge magazine if previously removed.
9. Restore the library configuration. See "Saving and Restoring Configuration
10. From the Operator Panel, select Run Library Verify, and press Enter to run
11. Take the library online.
Important: Do not stack objects on top of the library.
For more detailed instructions, see Chapter 3, "Installation and Configuration," on
page 3-1.
8-6
TS2900 Tape Autoloader Setup, Operator, and Service Guide
library (Figure 8-10).
library.
a. Connect the SAS host interface cable.
b. Connect the Ethernet cable.
c. Connect the power cable from the library power supply. Route all cables
through the hook and loop fastener strap.
d. Power ON the library by toggling the power supply switch to the ON (|)
position.
Settings" on page 4-28.
library diagnostics. Follow the on-screen instructions. If an error occurs, see
Chapter 6, "Troubleshooting," on page 6-1.
.
1
1
on the rear of the
4
4