Step 6: Configuring The Library - IBM System Storage TS3310 Setup And Operator Manual

4. When initialization is complete, configure the library.

Step 6: Configuring the Library

Now it is time to configure the library using the Setup Wizard. Read the
information in Chapter 4, "Configuration Planning," on page 4-1 and Chapter 5,
"User Interfaces," on page 5-1 before proceeding to Chapter 6, "Configuring the
Library," on page 6-1.
Note: If the operator panel does not initialize, check all cable connections, and
ensure that all doors are tightly closed and all power supply switches are
in the ON position. Then, repeat steps 1 and 2.
Chapter 3. Installing the Library
3-23