Securing The Rear Of The Library In The; Removing Accessor Locking Screw - IBM TS2900 Setup, Operator, And Service Manual

Figure 8-22. Securing the rear of the library in the rack
8. Run the SAS cable, power cable, and Ethernet cable through the hook and loop
Figure 8-23. The cables at the rear of the library
9. Remove the Accessor locking screw
Figure 8-24. Removing Accessor locking screw
10. On the rear panel of the library:
11. Insert the cartridge magazine if previously removed.
12. Restore the library configuration. See "Saving and Restoring Configuration
8-12
TS2900 Tape Autoloader Setup, Operator, and Service Guide
10
fastener strap , then tighten the strap (Figure 8-23).
12
12
a. Connect the SAS host interface cable.
b. Connect the Ethernet cable.
c. Connect the power cable or rack PDU line cord to the library power supply.
d. Power ON the library by toggling the power supply switch to the ON (|)
position.
Settings" on page 4-28.
10
.
1
1