• IP Address — If DHCP is disabled, set the IP address of the library manually.
• Subnet Mask — If DHCP is disabled, set the IP address of the subnet mask.
• Gateway — If DHCP is disabled, set the IP address of the gateway.
Configuring Operator Panel Settings
Figure 4-23. Operator Panel settings
Use Configuration → Configure Op Panel Settings to set the preferences when
using the Operator Panel.
Configure the Operator Panel using the following settings:
• Back light — Select to enable the LCD back light when using the Operator Panel.
• Login Password — Select to change the Operator Panel 4-character login
Setting the Library to Factory Defaults
Figure 4-24. Factory default settings
Use Configuration → Set Default to reset the library to the factory default settings.
See Table 3-4, "Default library configuration settings," on page 3-15. The date and
time must be reset after restoring factory default settings. See "Configuring Date and
Time Settings" on page 4-9.
Important: This configuration setting deletes all current library settings, and should
– IPv4 — Select to enter the library IP address using the IPv4 protocol.
– IPv6 — Select to enter four library IP addresses using the IPv6 protocol.
– Subnet Mask — Select to enter the subnet mask address using the IPv4 protocol.
– Prefix Length — Select to enter the prefix length for the IPv6 protocol.
– IPv4 — Select to enter the gateway IP address using the IPv4 protocol.
– IPv6 — Select to enter four gateway IP addresses using the IPv6 protocol.
Configuration
Configure Op Panel Settings
Configure LCD Back Light
Enable Auto Back Light
Input Count (min)
Disable Auto Back Light
Change Login Password
New Password
Reenter Password
– Input Count — If the auto back light is enabled, specify the time duration before
the back light turns OFF. The setting uses a 4-digit timer in minutes.
password. The new password must be re-entered for confirmation before the
password is changed (default: 0000).
Configuration
Set Default
be used with utmost caution.
4-11
Chapter 4. Operations