Encryption Settings Screen; Configuring Encryption Settings - IBM TS2900 Setup, Operator, And Service Manual

• Security — Select Enable SSL for Web to provide secure communications between
• IPv4 setting — Select Use IPv4 to enable the IPv4 Internet Protocol. Select the
• IPv6 setting — Select Use IPv6 to enable the IPv6 Internet Protocol. Select the
• DNS setting — Select Use DNS to use a domain name server. The DNS server, if
Click Submit to transfer the settings to the library. A dialog message is displayed
when the settings have been updated successfully.
Click Refresh to read the current settings from the library.

Configuring Encryption Settings

Figure 4-42. Encryption settings screen
Use Configure Library → Encryption to configure an encryption method for data
being stored on tape cartridges. The library supports transparent library-managed
the web browser and the tape library.
corresponding radio button to obtain an IP address automatically (DHCP) or use
static IP address settings. Enter the following parameters if using static IP address
settings.
– IPv4 address — Sets the TCP/IPv4 address of the library on the network.
– Subnet mask — Defines and limits users within a local network.
– Gateway — Allows access outside the local network.
corresponding check boxes to obtain an IP address automatically (DHCP), to
obtain an IP address using stateless auto configuration, or use static IP address
settings. Enter the following parameter if using static IP address settings.
– IPv6 address — Sets the TCP/IPv6 address of the library on the network.
– Prefix Length — Decimal value between 0 and 128 indicating the number of
contiguous, high-order bits comprising the network portion of the address.
– Gateway — Allows access outside the local network.
entered, allows the encryption, date and time, and notifications IP addresses to be
specified using hostnames instead of numerical IP addresses.
– DNS IP address — Sets the IP address of the DNS server.
4-23
Chapter 4. Operations