Configuring Trap Notifications; Trap Notifications - IBM TS2900 Setup, Operator, And Service Manual

2. Click on the SMTP (Mail) Settings tab.
3. Configure the SMTP server and header settings.
4. Enter the e-mail addresses to be notified when an event takes place in the Mail
5. Select the event level to report in the Mail Event field.
6. Click Test to send a test e-mail message to the enabled addresses.
7. Click Submit to enable the settings.

Configuring Trap Notifications

Figure 3-26. Trap notifications
Note: This is an optional procedure.
The traps supported by the TS2900 Tape Autoloader are listed in "Trap Definitions
(Types)" on page B-12.
To set up trap notifications for an SNMP server, complete the following procedure:
1. Expand Configure Library, if necessary, and click on Notifications in the left
2. Click on the SNMP Settings tab.
3. Configure the SNMP server and header settings.
• SMTP server address — SMTP mail server address. IPv4 and IPv6 addresses
are supported. Hostnames can be entered instead of numerical IP addresses if
the DNS server is specified in the Network settings.
• Sender address — Mail header information.
• Subject — Mail header information.
To fields.
navigation pane of the Web User Interface.
• Community — SNMP community name to which the library belongs.
• Name — Unique SNMP name for the system.
• Location — Physical location of the system.
• Contact — Contact person's name.
• SNMPv3 engine ID — A read-only attribute identifying the SNMPv3 engine.
Chapter 3. Installation and Configuration
3-25