housing. Move to Ship Position finishes all active commands received from the host
application, does not process any new commands, and moves the Accessor to the
parked position before the power is turned OFF.
Select Execute to unlock the cartridge magazine to remove the cartridges. Reinsert the
cartridge magazine before moving the tape library. The Accessor assembly is secured
in place using the Accessor locking screw that came with the library. The Accessor
locking screw is located on the rear panel of the library.
Rebooting the Drive
Figure 4-14. Reboot Drive command
Use Commands → Reboot Drive to force the drive to reboot. You also specify
whether the library should come online/offline after it finishes rebooting.
Select Execute to reboot the drive.
Rebooting the Library
Figure 4-15. Reboot Library command
Use Commands → Reboot Library to force the library to reboot. You also specify
whether the library should come online/offline after it finishes rebooting.
Select Execute to reboot the library.
Logging Out of the Library
Figure 4-16. Logout command
Use Logout to logout of the library. The login screen is displayed for the next user.
Configuring the Library
Configuring the I/O Station
Figure 4-17. I/O Station setting
Use Configuration → Configure Library → Configure I/O Station to enable or
disable Column 5, Tier 1 in the magazine as an I/O Station slot.
Commands
Reboot Drive
Commands
Reboot Library
Logout
Configuration
Configure Library
Configure I/O Station
Enable I/O Station
Disable I/O Station
4-7
Chapter 4. Operations