Attaching The Leader Pin Attach Tool To The Cartridge - IBM TS2900 Setup, Operator, And Service Manual

Figure 5-12. Attaching the leader pin attach tool to the cartridge
2. To find the end of the tape inside the cartridge, attach the cartridge manual
3. Continue to turn the rewind tool counterclockwise until approximately 13 cm (5
4. Remove the rewind tool by pulling it away from the cartridge. Set the tool and
To hold the cartridge door open, hook the tool into the door and pull the tool
back.
rewind tool ( in Figure 5-13) to the cartridge's hub
1
between the teeth of the hub. Turn the tool clockwise until you see the end of the
tape inside the cartridge. Then, slowly turn the rewind tool counterclockwise to
bring the tape edge toward the cartridge door
in.) of tape hangs from the cartridge door. If necessary, grasp the tape and pull
gently to unwind it from the cartridge.
the cartridge aside.
by fitting the tool's teeth
2
.
3
Chapter 5. Media
5-15