Network Settings Screen; Configuring Network Settings - IBM TS2900 Setup, Operator, And Service Manual

• Number of active slots — Select the number of active slots and the I/O Station
Click Submit to transfer the settings to the library. A dialog message is displayed
when the settings have been updated successfully.
Click Refresh to read the current settings from the library.

Configuring Network Settings

Figure 4-41. Network settings screen
Use Configure Library → Network to set the network settings for the library.
Note: The internet protocol (IPv4, IPv6 or dual IPv4/IPv6) selection is used for the
Configure the network using the following settings:
• Link speed — Ethernet duplex mode (Auto, 10Base-T Full, 10Base-T Half,
• TCP/IP settings — IPv4, IPv6, and dual stack IPv4/IPv6 are supported. To enable
4-22
TS2900 Tape Autoloader Setup, Operator, and Service Guide
cartridge position has been filled and sent back to its home position. This allows
endless backup operations without user interaction.
Autoload — Sequential mode with autoload mode ON loads the first available
cartridge (the lowest Column/Tier cartridge position that contains a cartridge)
automatically if the library powers ON with an empty drive.
configuration you would like to assign in your library. The first digit configures the
number of active storage positions (4, 6, 8, or 9). The second digit configures
Column 5, Tier 1 of the magazine as an I/O Station (0 when disabled, and 1 when
enabled). The Auto Cleaning function can be enabled only if there is at least 1
inactive position in the magazine. If Auto Cleaning is enabled, the inactive
positions become cleaning cartridge positions.
TS2900 Tape Autoloader IP address, subnet mask, gateway address, time
server address, mail server address, SNMP trap address, and EKM server
addresses.
100Base-TX Full, 100Base-TX Half).
the dual IPv4/IPv6 protocol, select both Use IPv4 and Use IPv6 and enter
parameters for both.