Web User Interface; Logging In; Confirmation Screen; Java Security Warning Message - IBM TS2900 Setup, Operator, And Service Manual

Figure 2-5. Confirmation screen

Web User Interface

The Web User Interface Java Applet requires Java 1.5.0 or higher be installed on your
host computer for full functionality, and is best viewed using Internet Explorer 6.0 or
higher. Internet Explorer 7.0 or higher is required for IPv6. If your computer does not
have Java installed or you need to upgrade your installation, download the latest
version of the Java Runtime Environment (JRE) for your platform from
http://www.java.com/ and follow the instructions provided to enable and configure
the Java Runtime Environment for your browser.
The Web User Interface can also be used to update the library and drive firmware,
and to download error logs, drive dumps, and other library data from the library.
Before the TS2900 Tape Autoloader can be managed over a network using the Web
User Interface, you must set up the initial network configuration of the library using
the Operator Panel. For more information, see "Configuring Network Settings" on
page 3-29.

Logging in

To log in to the Web User Interface from Internet Explorer, you need to enter the IP
address of the library. The IP address can be obtained using the View Settings
command from the Operator Panel. For example, http://192.168.1.1
When the applet launches, the following warning message appears. This message is
normal and does not indicate a problem.
Figure 2-6. Java security warning message
You can click the Always trust content from this publisher check box to avoid the
warning message in subsequent browser sessions.
2-5
Chapter 2. User Interfaces