Choosing A Location; Installing The Deskside Cover; Location Criteria; Deskside Kit - IBM TS2900 Setup, Operator, And Service Manual

The following additional items are required for installation and library operation:
• SAS cable
• Data cartridges
• Cleaning cartridge
• Ethernet cable
Important: If any of the contents of your shipment are damaged or missing, please

Choosing a Location

Choose a location that meets the following criteria:
Table 3-1. Location criteria
Criteria
Room temperature
Voltage
Frequency
Relative humidity
Air quality
Clearance
Rack requirements

Installing the Deskside Cover

A deskside cover and six feet must be installed on the library chassis before the
library can be used as a desktop unit. If you intend to install the library in a rack, skip
this step and proceed to "Installing in a Rack" on page 3-5.
Table 3-2 lists the parts in the deskside assembly kit. A Phillips head screwdriver
(preferably with a magnetic head) will be needed to assemble the deskside kit.
Table 3-2. Deskside kit
Number Part Number
45E3240
1
3-2
TS2900 Tape Autoloader Setup, Operator, and Service Guide
call the appropriate number listed on the Quality Hotline card.
Definition
16 to 32 °C (60 to 90 °F)
100 to 240 Vac. (4.0 to 1.5 A)
Note that the power switch is located on the rear of the library and
must be easily accessible at all times.
50 to 60 Hz
20 to 80% non-condensing
The library should be placed in an area with minimal sources of
particulate contamination. Avoid areas near frequently used doors and
walkways, stacks of supplies that collect dust, printers, and
smoke-filled rooms. Excessive dust and debris can damage cartridges
and the tape drive.
• Back: Minimum of 15 cm (6 in.)
• Front: Minimum of 30 cm (12 in.)
• Sides: Minimum of 5 cm (2 in.)
Standard EIA 19-inch rack: 1U space
Quantity Description
6 1U desktop foot
Part