Cover; Removing/Reinstalling The Tape Drive From/In The Library - IBM TS2900 Setup, Operator, And Service Manual

Removing/reinstalling the Tape Drive from/in the Library

To remove the SAS tape drive from the library, complete the following steps:
1. Turn OFF the power to the library.
2. Disconnect all cables from the rear panel of the library.
3. Remove the library cover(s). See "Removing/reinstalling the Library Chassis
4. Disconnect the internal SAS cable (
Figure A-12. Rear panel of the SAS Half-high drive
5. If connected, disconnect the internal LDI (RS-422) cable from the LDI (RS-422)
6. Remove the cartridge magazine from the library.
7. Remove the drive mounting screws from the sides of the tape drive housing. Two
Figure A-13. Drive housing screw locations
8. Lift the tape drive out of the library chassis (Figure A-14).
A-10
TS2900 Tape Autoloader Setup, Operator, and Service Guide
Cover" on page A-5.
4
1 2
connector ( in Figure A-12).
3
screws are located on each side of the drive (Figure A-13).
in Figure A-12).
2
3