7. Slide the library chassis into the rack. Secure the front of the library to the rack
Figure 3-11. Securing the front of the library in the rack
8. Secure the rear of the library to the rack using a round-head screw
Figure 3-12. Securing the rear of the library in the rack
9. Run the SAS cable, power cable, and Ethernet cable through the hook and loop
using the large black screws
(Figure 3-11).
11
bracket (Figure 3-12). Tighten the other rear bracket screws to secure the library
to the rack.
10
fastener strap
, leaving enough slack to reach the corresponding connectors,
12
then tighten the strap (Figure 3-13).
in the bottom holes on each front bracket
11
10
Chapter 3. Installation and Configuration
on each rear
10
3-11