IBM TS2900 Setup, Operator, And Service Manual page 198

Table B-1. Library error codes (continued)
Code (H) Description
X calibration error #3.
During X-drive calibration,
centering sensor OFF
008A
condition could not be
detected. Suspect the
centering sensor, X motor, or
P motor.
X calibration error #4.
During X-drive calibration,
centering sensor ON
008B
condition could not be
detected. Suspect the
centering sensor, X motor, or
P motor.
During X operation, the
cartridge magazine was
008F
removed. Suspect the
magazine set sensor.
Failed to detect media in the
Accessor at completion of
00B0 GET operation. Suspect the
centering sensor, X motor, or
P motor.
No media is contained in the
specified cell (Cell Empty).
00B1
Suspect the centering sensor,
X motor, or P motor.
Media detected in the
Accessor at completion of
00B2
centering check operation.
Suspect the centering sensor.
Media detected in the
Accessor at completion of
00B3
PUT operation. Suspect the
centering sensor.
Accessor error #1.
Reverse REV position (PP1)
error (Accessor origin not
00B8
detected or FWD position
detected). Suspect the P
origin sensor, FWD sensor, or
P motor.
B-6
TS2900 Tape Autoloader Setup, Operator, and Service Guide
Panel Indication
Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
CHK 008A
• If the problem persists, see "Contacting IBM
Technical Support" on page 7-1.
CHK 008B
1. Confirm the magazine is closed.
2. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
CHK 008F
• If the problem persists, see "Contacting IBM
1. Confirm the media is compatible.
2. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
CHK 00B0
• If the problem persists, see "Contacting IBM
Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
CHK 00B1 before resuming normal library operations.
• If the problem persists, see "Contacting IBM
Technical Support" on page 7-1.
1. If the cartridge remains in the Accessor, try to
move the cartridge from the Accessor to the I/O
CHK 00B2
Station using the Operator Panel or Web User
Interface. Remove the cartridge from the library
and inspect for damage and replace, if
necessary.
2. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
CHK 00B3
• If the problem persists, see "Contacting IBM
Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
CHK 00B8
• If the problem persists, see "Contacting IBM
Technical Support" on page 7-1.
Action Required
before resuming normal library operations.
Technical Support" on page 7-1.
before resuming normal library operations.
Technical Support" on page 7-1.
before resuming normal library operations.
Technical Support" on page 7-1.