Snmp Settings Screen; Configuring Snmp Trap Notifications - IBM TS2900 Setup, Operator, And Service Manual

Click Test to send a test message to the addresses enabled in the Mail to fields.
Click Submit to transfer the settings to the library. A dialog message is displayed
when the settings have been updated successfully.
Click Refresh to read the current settings from the library.

Configuring SNMP Trap Notifications

Figure 4-46. SNMP settings screen
Use Configure Library → Notifications → SNMP Settings to configure the trap
settings for sending event information whenever an event of a certain level occurs,
and to register users who are permitted to access the tape library using SNMP Version
3. The traps supported by the TS2900 Tape Autoloader are listed in "Trap Definitions
(Types)" on page B-12.
Download the SNMP MIB file for this library from http://www.ibm.com/storage/
support. Install the MIB file on your SNMP server. Refer to your server application
documentation for instructions.
Configure SNMP trap notification using the following settings:
• Community — SNMP community name (for example, "public")
• Name — Device name (for example, "TS2900 Tape Autoloader")
• Location — Physical location of the tape library
• Contact — Contact individual's name
• SNMPv3 engine ID — A read-only attribute identifying the SNMPv3 engine.
• Trap event — Event level notification threshold
– Error events
– Error and Warning events
– Error, Warning, and Information events
– Error events
– Error and Warning events
4-27
Chapter 4. Operations