Installing The Library In A Rack; Removing Side Rails From The Library - IBM TS2900 Setup, Operator, And Service Manual

12. Remove the flat-head screws
6
Figure 8-16. Removing side rails from the library chassis

Installing the Library in a Rack

For details on the rack mount kit components, see "Installing in a Rack" on page 3-5.
1. Determine the location in your rack for your library and mark with a pencil. For
2. Attach the left
8
Figure 8-17. Attaching the front brackets to the library chassis
3. Attach the left
rails from the chassis (Figure 8-16).
details on rack mount locations, see "Installing in a Rack" on page 3-5.
and right
3
using two flat-head screws
screw holes on each side.
3
and right
1
using two round-head screws
Note: Run the hook and loop fastener strap through the slot on the right rear
bracket and attach it back upon itself.
on each side to remove the left
6
5
front brackets to the front of the library chassis
4
on each side (Figure 8-17). Use the bottom two
8
4
8
rear brackets to the left
2
on each side (Figure 8-18).
10
Chapter 8. Removal and Replacement Procedures
and right
5 3
3
6
and right front rails
5 6
8-9