Trap List Settings; Snmpv3 User List Settings - IBM TS2900 Setup, Operator, And Service Manual

4. Enter the trap IP addresses of the SNMP monitoring stations to be notified when
Figure 3-27. Trap list settings
5. Enter the SNMPv3 users who are permitted to access the tape library in the
Figure 3-28. SNMPv3 user list settings
3-26
TS2900 Tape Autoloader Setup, Operator, and Service Guide
an event takes place and the security settings in the Trap List pop-up menu.
• Validity — Enable/Disable setting.
• Trap version — v1, v2c, or v3. For v2c and v3, the Inform checkbox
determines whether an SNMP INFORM request is sent instead of a trap event.
• IP address — IPv4 and IPv6 addresses are supported. Hostnames can be
entered instead of numerical IP addresses if the DNS server is specified.
• Community (v1 or v2c) — SNMP community name.
• User name (v3 only) — SNMPv3 unique user name.
• Authentication (v3 only) — Authentication algorithm, MD5 or SHA. When an
algorithm is specified, an authentication password and confirmation of the
password are required.
• Privacy (v3 only) — Privacy service encryption and decryption algorithm, DES
or AES. When an algorithm is specified, a privacy password and confirmation
of the password are required.
SNMPv3 User List pop-up menu.
• Validity — Enable/Disable setting.
• User name — SNMPv3 unique user name.
• Authentication — Authentication algorithm, MD5 or SHA. When an
algorithm is specified, an authentication password and confirmation of the
password are required.