Entering Email Notification; Configuring Snmp Settings; The Configure Library: Email Notification - IBM TS3100 Setup, Operator, And Service Manual

Entering email notification

About this task
This function is not available on the Operator Control Panel.
Use this menu item to set up email notification of library errors and warnings.
Procedure
1. Click Configure Library > Email Notification in the left navigation pane.
Figure 54. The Configure Library: Email notification screen
2. If you want to be notified when an error occurs, select Notify Errors.
3. If you want to be notified when a warning occurs, select Notify Warnings.
4. In To Email Address, enter the email address to which the information is sent.
5. In SMTP Server Address (IPv4 or IPv6), enter the IP address of the SMTP server that is associated
with the email address.
6. Enter the Domain Name for your library. This field cannot be blank when event notification is used.
Note: If you attempt to enter a blank value for the Domain name, a warning message displays. It
says If you are using Event Notification then a value is required for the Domain Name.
7. Click one:
v Refresh - to cancel all of your entries and leave the settings as they were.
v Submit - to apply the changes that are made to the screen.

Configuring SNMP settings

This page shows the current SNMP configuration of the library and allows modification to the
configuration. When a change is requested, a box checks to confirm the changes.
Click SNMP in the left navigation pane to display the SNMP page.
Installation and configuration
71