Removing Gearbox - Skoda Fabia II 2007 Workshop Manual

– Remove the cap from assembly opening for the converter
nuts.
– Unscrew the 6 nuts -arrow- from the torque converter. To do
so turn the crankshaft each time 60°.
Note
If not all 6 nuts are unscrewed from the torque converter, the tor‐
que converter is pulled out when removing the gearbox from the
engine!
– Lower the engine/gearbox assembly with the spindle approx.
50 mm.
– Mount engine/gearbox jack - 3282- onto engine/gearbox
mount - V.A.G 1383A- .
– Position adjusting plate - 3282/36- onto the gearbox mount -
3282- (adjusting plate fits in only one position).
– Align arms of the gearbox mount with the holes in the adjusting
plate.
– Screw in the mounting elements as shown on the adjusting
plate.
– Position engine/gearbox jack - V.A.G 1383A- below vehicle,
arrow symbol on adjusting plate points in the direction of travel.
– Align the adjusting plate parallel to the gearbox.
– Secure the gearbox on the gearbox support - 3282- using
screw -1-.
– Support gearbox by raising the gearbox mount.
– Unscrew the remaining connecting screws of the engine/gear‐
box. Installation position
⇒ "3.3 Tightening torques ", page 134
– Push gearbox off engine, simultaneously press off the torque
converter from the driver disc.
– Push torque converter against the ATF-pump -arrow-.
– Carefully swivel gearbox towards the assembly carrier.
– Carefully lower the gearbox and guide past the assembly car‐
rier downwards.
– Change the gearbox position at the spindles of the gearbox
mount - 3282- when lowering.
– Secure torque converter against dropping out.
3.1.2 Removing gearbox Octavia II
Special tools and workshop equipment required
♦ Supporting device - T30099-
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
.
Gearbox 09G - Edition 07.2014
3. Removing and installing the gearbox
111