Skoda Fabia II 2007 Workshop Manual page 166

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
– Seal the hoses of the ATF radiator with hose clamps -
MP7-602 (3094)- .
– Remove hoses from the ATF radiator.
– Unscrew screws-arrows- and remove ATF radiator.
Install
Installation is carried out in the reverse order. Pay attention to the
following:
• Always replace O-rings of ATF radiator ⇒ Electronic Cata‐
logue of Original Parts .
• Connect the coolant hoses to the ATF radiator using the mark‐
ings made during removal.
• Check coolant level in the cooling system ⇒ Engine; Rep. gr.
19 .
• Inspecting ATF level and if necessary topping up
⇒ page 147 .
– Install the battery tray and battery ⇒ Electrical System; Rep.
gr. 27 .
– Install air filter ⇒ Engine; Rep. gr. 24 .
– Install engine cover ⇒ engine; Rep. gr. 10 .
Tightening torques
Component
ATF radiator to gearbox
5.2.3 Removing and installing ATF radiator
(Yeti)
Special tools and workshop equipment required
♦ Hose clamp - MP7-602 (3094)-
Removing
– Remove air filter ⇒ Engine; Rep. gr. 24 .
Caution
Touch an earthed object before working on the electrical com‐
ponents. Do not grab directly at the plug contacts or electronic
components.
Observe measures when disconnecting and connecting the
battery ⇒ Electrical System; Rep. gr. 27 .
162
Rep. gr.37 - Controls, housing
Nm
⇒ "5.1 ATF radiator -
Summary of compo‐
nents", page 155