Skoda Fabia II 2007 Workshop Manual page 135

– Swivel the spring unit outwards- while doing so, press the drive
shaft out of the gearbox mounting by hitting on it with a plastic
hammer on the wedge - T10161- .
– Tie up drive shaft.
– Repeat the same procedure on the opposite side of the vehicle
as well.
– Remove the cap - where present - from assembly opening for
the converter nuts.
– Unscrew the 3 nuts -arrow- from the torque converter. To do
so turn the crankshaft each time 120°.
Caution
If not all 3 nuts are unscrewed from the torque converter, the
torque converter is pulled out when removing the gearbox from
the engine!
– Lower the engine/gearbox assembly with the spindle approx.
50 mm.
– Position gearbox mount - 3282- on the engine/gearbox jack -
V.A.G 1383A- .
– Install the gearbox mount - 3282- as follows:
• Move the engine/gearbox jack - V.A.G 1383A- with gearbox
mount - 3282- underneath the gearbox-1-.
• Set the engine/gearbox jack - V.A.G 1383A- with gearbox
mount - 3282- in such a way that the spindles -A- and -B- face
ahead in the driving direction.
• Insert the support -2- into the groove of the oil sump all the
way around as shown.
• Lock the bolts -3- into the countersink on the gearbox, front
right.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
3. Removing and installing the gearbox
131