Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
– Press together the catches at the cable support of the selector
lever control cable -arrows- and pull out the selector lever
control cable from the cable support/gearbox.
– Lever off selector lever control cable in such a way that the
extremity can move freely.
•
Do not bend or buckle selector lever control cable.
For vehicles Octavia III and Yeti
– Unlock the quick-release lock -3- at the mounting bracket -2-
and unhook the selector lever control cable -1-.
– Unscrew the screws -arrows-, remove the support for the se‐
lector lever control cable -4- and place it to one side.
Note
Do not remove the circlip -5-.
♦
Do not bend or buckle the selector lever control cable.
♦
Continued for all vehicles
– Shift selector lever from "P" to "S".
– Check front boot on the selector lever cable control for dam‐
age, if necessary replace control cable.
– Shift selector lever into position "P".
•
Gearshift mechanism and selector lever control cable must
move smoothly when shifting gears. On some vehicles, you
can replace the selector lever control cable separately.
•
Selector lever control cable can be replaced as a separate part
or only on the vehicles:
•
⇒ "2.1.1 Summary of components - Gearshift mechanism -
Octavia II up to 10.2009", page 41
•
⇒ "2.1.4 Summary of components - Shift mechanism up to
10.2011 (Fabia II and Roomster)", page 47
– Carefully push the selector lever control cable onto the gear‐
shift lever and insert into the cable support/gearbox.
Setting
The selector lever control cable must be set, if:
♦ the selector lever control cable was removed from the gear‐
box,
♦ the engine was removed and installed or the gearbox was re‐
moved and installed,
♦ the selector lever control cable or the shift mechanism was
removed and installed,
♦ The position of the engine/gearbox was changed, e.g. during
a stress-free assembly of the unit.
– Shift selector lever into position "P".
56
Rep. gr.37 - Controls, housing
.
.