Skoda Fabia II 2007 Workshop Manual page 117

– Clamp off the ATF-radiator hoses with hose clamps - MP7-602
(3094)- and remove from ATF-radiator.
– Seal the of the ATF radiator with a clean plug.
– Release all connecting screws of the engine/gearbox acces‐
sible from the top.
Installation positions: ⇒ "3.3 Tightening torques ", page 134
– Fit supporting device -T30099- .
– Remove the filling pieces from both upper edges of the wings.
– Tighten the holder - T10346- on the rear of the three location
holes for the battery tray.
– To do so, use a collar screw M6 or one of the fixing screws for
the battery tray.
– Position the supporting device - MP9-200 (10-222A)- behind
the pressurized gas strut -A- for the front flap.
– The feet of the supporting device must be placed as shown in
the illustration, behind the screws -arrow 1- and sideways up
to the screw -arrow 2- on the frame side rails for wheel arches
at the top.
– Connect the holder - T10346- with the supporting device .
– Hook the second spindle to the front left engine lifting eye.
– Take up the weight of the engine/gearbox unit at the spindles.
– Remove gearbox console -A-, to this end release screws -1-
and -2-.
– Remove both front wheels.
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
– Remove the bottom part of the front wheelhouse liner ⇒ Body
Work; Rep. gr. 66 .
– Disconnect plug connection -1- at oil level and oil temperature
sender - G266- .
– Unclip the mounting bracket -2- for the electrical cable to the
oil level and oil temperature sender - G266- at the assembly
bracket.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
3. Removing and installing the gearbox
113