Skoda Fabia II 2007 Workshop Manual page 112

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
– Lever off the selector lever control cable -3- from gearshift
lever, e.g. using an open-end wrench -1-.
– Press together the catches at the cable support of the selector
lever control cable -arrows- and pull out the selector lever
control cable from the cable support/gearbox.
– Disconnect plug connection -4- and expose electrical cable at
bracket -2-.
– Unscrew the cable support for the selector lever control cable
from the gearbox.
– Unscrew earth strap -3-.
– Detach electrical cables -1- and -2- at starter and expose.
– Mark hoses of ATF radiator to ATF radiator, in order to prevent
interchanging when installing.
Note
Depending on the as-built configuration a small plastic tube is lo‐
cated in the feed of the ATF radiator, which must be re-installed
during installation.
– Clamp off the ATF-radiator hoses with hose clamps - MP7-602
(3094)- and remove from ATF-radiator.
– Seal the of the ATF radiator with a clean plug.
– Release all connecting screws of the engine/gearbox acces‐
sible from the top.
– Remove the filling pieces from both upper edges of the wings.
– Tighten the holder - T10346- on the rear of the three location
holes for the battery tray.
– To do so, use a collar screw M6 or one of the fixing screws for
the battery tray.
– Position the supporting device - MP9-200 (10-222A)- behind
the pressurized gas strut -A- for the front flap.
– The feet of the supporting device must be placed as shown in
the illustration, behind the screws -arrow 1- and sideways up
to the screw -arrow 2- on the frame side rails for wheel arches
at the top.
– Connect the holder - T10346- with the supporting device .
– Hook the second spindle to the front left engine lifting eye.
– Take up the weight of the engine/gearbox unit at the spindles.
108
Rep. gr.37 - Controls, housing