Skoda Fabia II 2007 Workshop Manual page 130

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
– Install the gearbox mount - 3282- as follows:
• Move the engine/gearbox jack - V.A.G 1383A- with gearbox
mount - 3282- underneath the gearbox-1-.
• Set the engine/gearbox jack - V.A.G 1383A- with gearbox
mount - 3282- in such a way that the spindles -A- and -B- face
ahead in the driving direction.
• Insert the support -2- into the groove of the oil sump all the
way around as shown.
• Lock the bolts -3- into the countersink on the gearbox, front
right.
– Screw in the support with bolts - VAS 3282/29- into the rear
bore for pendulum support at the gearbox -1-.
– Support the gearbox by carefully raising the engine/gearbox
jack - V.A.G 1383A- .
– Remove the connecting screws for the engine/gearbox
-A-,-B- and then all the remaining connecting screws.
Installation positions of the engine/gearbox screws
⇒ "3.3 Tightening torques ", page 134
Caution
When removing the gearbox, pay attention to the torque con‐
verter.
Prevent it from falling out.
– Push gearbox off engine, simultaneously press the torque
converter against the ATF pump -arrow-.
– Carefully lower the gearbox and guide past the assembly car‐
rier downwards.
Note
Change the gearbox position at the spindles of the gearbox mount
- 3282- when lowering.
126
Rep. gr.37 - Controls, housing
.