Skoda Fabia II 2007 Workshop Manual page 121

– Mount engine/gearbox jack - 3282- onto engine/gearbox
mount - V.A.G 1383A- .
– Position adjusting plate - 3282/36- onto the gearbox mount -
3282- (adjusting plate fits in only one position).
– Align arms of the gearbox mount with the holes in the adjusting
plate.
– Screw in the mounting elements as shown on the adjusting
plate.
– Position engine/gearbox jack - V.A.G 1383A- below vehicle,
arrow symbol on adjusting plate points in the direction of travel.
– Align the adjusting plate parallel to the gearbox.
– Secure the gearbox on the gearbox support - 3282- using
screw -1-.
– Support gearbox by raising the gearbox mount.
– Unscrew the remaining connecting screws of the engine/gear‐
box.
Installation positions: ⇒ "3.3 Tightening torques ", page 134
– Push gearbox off engine, simultaneously press off the torque
converter from the driver disc.
– Push torque converter against the ATF-pump -arrow-.
– Carefully swivel gearbox towards the assembly carrier.
– Carefully lower the gearbox and guide past the assembly car‐
rier downwards.
– Change the gearbox position at the spindles of the gearbox
mount - 3282- when lowering.
– Secure torque converter against dropping out.
3.1.3 Removing gearbox Fabia II, Roomster,
Rapid
Special tools and workshop equipment required
♦ Supporting device - MP9-200 (10-222A)-
♦ Hook - MP9-200/10-
♦ Engine/gearbox jack - V.A.G 1383A-
♦ Hose clamp - MP7-602 (3094)-
♦ Gearbox mount - 3282-
♦ Adjusting plate - 3282/36-
♦ Wedge - T10161-
– Shift selector lever into position "P".
– Remove engine cover.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
.
3. Removing and installing the gearbox
117