Skoda Fabia II 2007 Workshop Manual page 18

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
♦ Always replace O-rings, gaskets and gasket rings.
♦ After removing gaskets, examine the contact surface in the
housing or on shafts for burrs or damage, and correct if nec‐
essary.
♦ Depending on location, before fitting a gasket ring, smear the
outer surface and sealing lip thinly with ATF or axle oil.
♦ The open side of the sealing rings faces the side with fluid
filling.
♦ Before inserting the O-rings coat with ATF to prevent the rings
being squashed during installation.
♦ Never use other lubricants in the ATF area.
♦ Radial shaft seals before mounting lightly oil at outside diam‐
eter and fill half the space between the sealing lips -arrow- with
sealing grease - G 052 128 A1- .
♦ After installation, inspect ATF level and if necessary top up
⇒ "4 ATF", page 147
Locking elements
♦ Do not over-extend the circlips, if necessary replace.
♦ Circlips must be positioned in the base of the groove.
Screws, nuts
♦ Slacken and tighten screws or fixing nuts of covers and hous‐
ings crosswise.
♦ Do not twist particularly sensitive parts - e.g. the slide valve
body - and slacken and tighten diagonally across in stages.
♦ Tightening torques apply for non-oiled nuts and bolts.
♦ Clean the thread of the screws that are inserted with a locking
agent with a wire brush. Next, insert screws using a suitable
locking agent ⇒ Electronic Catalogue of Original Parts .
♦ Clean all threaded holes into which bolts are screwed in with
locking agent , using a thread tap to remove old locking agent
residues. Otherwise there is a risk that the bolts will shear at
the next disassembling.
♦ Replace self-locking nuts and bolts each time they are re‐
moved.
♦ Bolts that still need to be turned at a certain angle after tight‐
ening must always be replaced.
Electrical components
This electrostatic charge can lead to operational problems after
touching the electrical components of the gearbox and the shift
mechanism.
– Touch an earthed object - e.g. a metal water pipe or a lift plat‐
form - before working on the electrical components. Do not
touch the contacts of the plugs and the »open« electrical com‐
ponents.
Targeted fault-finding
Before repairing the automatic gearbox 09G, try to determine the
origin of the damage as accurately as possible using the ⇒ Vehi‐
cle diagnostic tester in the "Targeted fault-finding" mode.
14
Rep. gr.00 - Technical data
.