Skoda Fabia II 2007 Workshop Manual page 173

Removing
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
– Position drip tray, e.g. -VAS 6208- under the gearbox.
WARNING
Wear safety goggles.
– Unscrew ATF inspection plug and ATF drain plug-A-.
– Release the overflow tube -C- (5 mm Allen key) and drain re‐
maining ATF.
– Loosen the 8 screws -arrows- of the oil pan crosswise.
WARNING
There is still ATF in the oil pan because not all of it could be
drained via the drain opening.
– Remove oil pan together with the oil pan gasket.
Install
Installation is performed in the reverse order, pay attention to the
following points:
– Clean the two magnets Pos. 7 in the oil pan beads
⇒ "1.2 Summary of components - oil pan, oil strainer, slide
valve body, internal wiring looms", page 165
the full surface of the magnets rests against the oil pan.
Note
The magnets must be absolutely fitted on the provided points in
the oil pan.
– Clean gaskets and sealing surfaces and eliminate residues of
oil.
– Pay attention to correct fitting of oil pan gasket.
– When positioning the oil pan no cables must be trapped.
– Screw in the 8 screws of the oil pan crosswise.
– Replace gasket ring of ATF drain plug ⇒ Electronic Catalogue
of Original Parts .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
. Take care that
1. Removing and installing oil pan, oil filter, slide valve body and internal wiring looms
Gearbox 09G - Edition 07.2014
169