– Push away selector lever control cable -2- in
-direction of arrow- from the selector lever -3-.
– Pull out securing clasp -1-.
– Pull the selector lever control cable out of the protective cover.
Continued for all vehicles
Note
Do not bend or buckle selector lever control cable.
– Remove selector lever control cable.
Install
Installation is performed in the reverse order, pay attention to the
following points:
Note
Inspect boot for damage; the boot must be replaced together
♦
with the selector lever control cable.
Check correct fitting of the boot and do not install the boot
♦
twisted.
For vehicles Octavia II (up to production date 10.2009)
Caution
♦ Under no circumstances touch the circuit board -B- of the
gearshift mechanism with the fingers, because static dis‐
charge can destroy the electronic components and the
circuit board.
♦ The circuit board can only be replaced together with the
gearshift mechanism!
– Insert the end of the selector lever control cable -4- into the
joint of the selector lever.
– Push the pin -3- downwards -arrow-.
– Check if the plastic securing spring -2- has locked the pin.
– Fit new locking clasp -1- for selector lever control cable at the
gearshift mechanism.
•
Fitting position: Angled end of locking clasp points towards the
inside of the gearshift mechanism.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
2. Repairing shift mechanism
97