Skoda Fabia II 2007 Workshop Manual page 54

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
needs to be unclipped
⇒ "2.14 Emergency release of gearshift mechanism out of position P ", page 105
❑ the symbol insert and the circuit board with the lamp for selector lever scale illumination - L101- are
integrated in the cover
3 - Open warm-type clamp
❑ replace ⇒ Electronic Catalogue of Original Parts
❑ tighten using hose binding claw - V.A.G 1275-
4 - Shift mechanism
❑ with selector lever lock solenoid - N110-
❑ ⇒ "2.14 Emergency release of gearshift mechanism out of position P ", page 105
❑ ⇒ "2.9 Removing and installing selector mechanism", page 74
❑ ⇒ "2.3 Inspecting and adjusting the selector lever control cable", page 55
❑ ⇒ Fig. ""Remove the shift mechanism together with the selector lever control cable from the shift hous‐
ing"" , page 51
5 - Screw
❑ 8 Nm
6 - Shift housing with gasket
❑ ⇒ Fig. ""Remove the shift mechanism together with the selector lever control cable from the shift hous‐
ing"" , page 51
7 - Nut
❑ 4 pieces
❑ 25 Nm
8 - Gearshift lever
9 - Cable support
❑ for selector lever control cable
10 - Screw
❑ for cable support to gearbox
❑ 2 pieces
❑ 23 Nm
11 - Selector lever control cable
❑ when installing in the vehicle, clamp on the gearbox side with the fixing part to the heat shield of the
exhaust system
❑ The selector lever control cable must not be separated from the shift mechanism Pos. 3, it must be
removed together as one component part ⇒ Electronic Catalogue of Original Parts.
❑ Do not grease selector lever control cable
❑ ⇒ Fig. ""Remove the shift mechanism together with the selector lever control cable from the shift hous‐
ing"" , page 51
❑ ⇒ "2.3 Inspecting and adjusting the selector lever control cable", page 55
12 - Support
❑ for selector lever control cable
13 - Nut
❑ for holder Pos. 12 at gearbox
❑ 13 Nm
50
Rep. gr.37 - Controls, housing