Skoda Fabia II 2007 Workshop Manual page 116

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
♦ Surface - T30099/1-
♦ Alignment rail - MP3-457/2 (VW 457)-
♦ Support device for engine - MP3-470 (3300A)-
♦ Hook - MP9-200/10-
♦ Engine/gearbox jack - V.A.G 1383A-
♦ Hose clamp - MP7-602 (3094)-
♦ Gearbox mount - 3282-
♦ Adjusting plate - 3282/36-
♦ Wedge - T10161-
Note
If the battery earth strap is disconnected and connected, carry
♦
out additional operations ⇒ Electrical System; Rep. gr. 27 .
All cable straps which are detached or cut open when remov‐
♦
ing, should be fitted on again in the same place when installing.
– Disconnect the battery-earth strap with the ignition off ⇒ Elec‐
trical System; Rep. gr. 27 .
– Shift selector lever into position "P".
– Remove engine cover ⇒ engine; Rep. gr. 10 .
– Remove air filter ⇒ Engine; Rep. gr. 24 .
– Remove battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
– Remove the cooling water tank cover ⇒ Body Work; Rep. gr.
66 .
– Lever off the selector lever control cable -3- from gearshift
lever, e.g. using an open-end wrench -1-.
– Press together the catches at the cable support of the selector
lever control cable -arrows- and pull out the selector lever
control cable from the cable support/gearbox.
– Disconnect plug connection -4- and expose electrical cable at
bracket -2-.
– Unscrew the cable support for the selector lever control cable
from the gearbox.
– Unscrew earth strap -3-.
– Detach electrical cables -1- and -2- at starter and expose.
– Mark hoses of ATF radiator to ATF radiator, in order to prevent
interchanging when installing.
Note
Depending on the as-built configuration a small plastic tube is lo‐
cated in the feed of the ATF radiator, which must be re-installed
during installation.
112
Rep. gr.37 - Controls, housing