Skoda Fabia II 2007 Workshop Manual page 131

– Prevent the torque converter from falling off, e.g. using a wire
-A-.
Note
The depiction of the torque converter and gearbox may vary.
3.1.5 Removing gearbox (Yeti)
Special tools and workshop equipment required
♦ Supporting device - T30099- with -10-222A/31-
♦ Supporting device - T40091/3-
♦ Hook - MP9-200/10-
♦ Adapter - MP9-200/18-
♦ Surface - T30119-
♦ Engine and gearbox jack - V.A.G 1383A-
♦ Hose clamp - MP7-602 (3094)-
♦ Gearbox mount - 3282-
♦ Bolt - VAS 3282/29-
♦ Wedge - T10161-
♦ Screw plug set for engine , e.g. -VAS 6122-
♦ Pliers for spring strap clamps
Note
If the battery earth strap is disconnected and connected, carry
♦
out additional operations ⇒ Electrical System; Rep. gr. 27 .
All cable straps which are detached or cut open when remov‐
♦
ing, should be fitted on again in the same place when installing.
– Shift selector lever into position "P".
– Disconnect the battery-earth strap with the ignition off ⇒ Elec‐
trical System; Rep. gr. 27 .
– Remove air filter ⇒ Engine; Rep. gr. 24 .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
3. Removing and installing the gearbox
127