Table of Contents
Advertisement
Icon
Parameter
Stop-Time for direction change
The waiting time at the turning points
(e.g. for a change of sewing direction)
is set at this point. A short waiting time in
milliseconds should ensure consistent
seam quality (ornamental-stitch bartack).
Stitch length default
If this function is active, the same needle
stitch length is used for the bartack as the
one set in Manual mode. If this function
is deactivated, a custom input can be
entered.
Speed in bartack
Single stitches per pedal
If this function is activated, each stitch in
the bartack can be sewn individually by
pressing the pedal. This function can only
be used meaningfully if the speed is set
very low for the bartack.
Needle thread tension default
If this function is active, the same needle
thread tension is used for the bartack as
the one set in Manual mode. If this function
is deactivated, a custom input can be
entered.
118
Operating Instructions D669 M-TYPE DELTA - 00.0 - 10/2020
Setting
Value range
0000 – 1000 [ms]
On/Off
Stitch length of stitches
forward
Value range
01.0 - 12.0 [mm]
(depending on subclass)
Stitch length of backwards
stitches
Value range
01.0 - 12.0 [mm]
(depending on subclass)
Value range
0000 - 2000
Value range
On/Off
Value range
On/Off
Programming
Advertisement
Table of Contents
