Lifting The Sewing Feet - Dürkopp Adler D669 Operating Instructions Manual

36
To adjust the needle thread regulator:
1. Loosen the screw (2).
• To increase the tension: Slide the needle thread
regulator (1) to the right
• To reduce the tension: Slide the needle thread
regulator (1) to the left
2. Tighten the screw (2).

4.10 Lifting the sewing feet

Fig. 16: Lifting the sewing feet
(1) - Pedal
To lift the sewing feet:
1. Press the pedal (1) halfway back.
 The machine stops and lifts the sewing feet.
The sewing feet remain up as long as the pedal is pressed
halfway back.
OR
1. Press the pedal (1) fully back.
 Thread cutting is activated, and the sewing feet are raised.
Operating Instructions D669 M-TYPE DELTA - 00.0 - 10/2020
Operation
①