Limit Position Control - Siemens SINAMICS G110M Operating Instructions Manual

Advanced commissioning

8.9 Limit position control

8.9 Limit position control
Overview
An end position is a position in the direction of motion of a machine component where motion
stops as a result of the inherent mechanical design. A limit switch is a sensor that signals that the
end position has been reached.
The end position control of the converter controls the motor depending on 2 limit switch signals:
• When an end position is reached, the converter stops the motor.
• At one end position, the converter prevents the motor from moving the machine
components further in the direction of this end position.
Function description
Figure 8-22
220
End position control of the converter
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL