Performance Ratings Power Module - Pm240M - Siemens SINAMICS G110M Operating Instructions Manual

Technical data

11.2 Performance ratings Power Module - PM240M

11.2 Performance ratings Power Module - PM240M
General performance ratings
Feature
Line operating voltage &
power ranges
Input frequency
Output frequency
cos φ
Converter efficiency
Overload capability (HO)
Inrush current
Pulse frequency
Electromagnetic compati‐
bility
Protection level
Temperature range
Storage temperature
Humidity
Operational altitude
Protection features
Standards
CE mark
EM Brake
390
Specification
3 AC 380 V (- 10%) ... 480 V (+ 10%)
High Overload: 0.37 kW ... 4.0 kW (0.5 hp ... 5.0 hp)
47 Hz ... 63 Hz
0 Hz ... 650 Hz
0.95
95% ... 97%
2 x Nominal output current for 3 seconds followed by 1.5 x Nominal output
current for 57 seconds every 300 seconds (averages as 110%).
For 4 kW variant:
1.6 x Nominal output current for 3 seconds followed by 1.5 x Nominal output
current for 57 seconds every 300 seconds (averages as 110%).
Less than rated input current
4 kHz (standard); 4 kHz ... 16 kHz (in 2 kHz steps)
Internal Class A filters according to EN 55011
IP65/IP66 (when Power Module and Control Unit is fully assembled).
CU: -10 °C ... +55 °C (14 °F ... 131 °F) - High Overload (HO)
-40 °C ... +70 °C (-40 °F ... 158 °F)
< 95% RH - non-condensing
Up to 1000 m (3280 ft) above sea level without derating
Undervoltage, Overvoltage, Overload, Ground faults, Short circuit, Stall pre‐
vention, Motor blocking protection, Motor overtemperature, Power Module
overtemperature, Parameter interlock
UL, cUL, CE, C-tick
Conformity with EC Low Voltage Directive 73/23/EEC and filtered versions
also Electromagnetic Compatibility Directive 89/336/EEC
180 V DC (400 V half-wave rectified) 1A maximum
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL
Distributed converter for SIMOGEAR geared motors