Go Online And Start The Commissioning Wizard - Siemens SINAMICS G110M Operating Instructions Manual

5.4.5.3

Go online and start the commissioning Wizard

Procedure
1. Select your project and go online:
2. In the following screen form, select the converter with which you wish to go online.
3. Once you are online, select "Commissioning" → "Commissioning Wizard":
You have started the commissioning Wizard of the converter.
❒
Procedure
The wizard only displays the "setpoint input" if you configured a converter with PROFINET or
PROFIBUS interface.
Select whether the converter is connected to a higher-level control via the fieldbus.
Select whether the ramp-function generator for the speed setpoint is implemented in the higher-
level control or in the converter.
Select the control mode.
Select the I/O configuration to preassign the converter interfaces.
Set the applicable motor standard and the converter supply voltage.
Select the application for the converter:
• "[0] Load cycle with high overload for applications requiring a high dynamic performance,
e.g. conveyor systems.
• "[1] Load cycle with low overload ..." for applications that do not require a high dynamic
performance, e.g. pumps or fans.
If a braking resistor is installed, you set the maximum braking power to which the braking
resistor will be subjected.
Select your motor.
Enter the motor data according to the rating plate of your motor.
If you have selected a motor based on its article number, the data has already been entered.
Select the temperature sensor for monitoring of the motor temperature.
Define whether the converter actuates a motor holding brake.
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL
Selecting the control mode (Page 127)
p0015 Default settings (Page 116)
Commissioning
5.4 Quick commissioning
125