Quick Commissioning With A Pc - Siemens SINAMICS G110M Operating Instructions Manual

Commissioning
5.4 Quick commissioning
Figure 5-24
5.4.5

Quick commissioning with a PC

The screen forms that are shown in this manual show generally valid examples. The number of
setting options available in screen forms depends on the particular converter type.
Commissioning with a PC
The following interfaces - which are control unit dependent - are available:
Table 5-3
Type
PC connected to CU using
Interface
Restrictions
In the following the commissioning via USB is described.
122
Default settings 34 - ASi Dual slave with setpoint
Connection possibilities for a PC
USB cable
Mini-USB
USB PROFIBUS
PROFIBUS interface
M12 - 5 pole connec‐
tor
- up to 125 slaves
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL
PROFINET
PROFINET interface
M12 - 4 pole connec‐
tor
None