Platform Control Display Panel - JLG 10MSP Operation And Safety Manual

SECTION 3 - MACHINE OPERATION

Platform Control Display Panel

1
Platform Control Display Panel
1. Battery Charge/Flash Code LEDS
2. Drive Speed Setting Indicator
3-24
1. Battery Charge/Flash (Fault) Code Indicator LEDS
On normal power-up and operation this series of ten (10)
LEDs visually indicates the amount of charge remaining in
the batteries.
The number of LEDs lit will change depending on the level
of charge in the batteries.
• (+) All Three GREEN LEDs lit up indicate maximum battery
charge.
• Four YELLOW LEDs indicate a two thirds to one third battery
4
charge remaining.
• (–) Three RED LED's lit indicate minimum battery charge
remaining. The machine will continue to operate at this
charge level but will begin to indicate low battery voltage
warning indicators.
NOTE: For more information on Battery Warning Level Indicators
See "Battery Low Voltage Warning Indicators".
This set of ten LEDs will also indicate a flash (fault) code if
other operating problems are detected by the Ground
Control Station. Fault codes are also accompanied by a
beeping alert from the platform control console.
NOTE: LED Flash (Fault) Code indications that may be corrected
by the operator are shown on Table 3-2 of this manual.
31215821