Lubrication Intervals For Various Components - JLG 10MSP Operation And Safety Manual

ITEM COMPONENT
Fill To Full Line on
1 Hydraulic Oil Dipstick - 5 Qt. Res-
ervoir
2 Swivel Raceways
3 Mast Chains 2 - Per Section
Key to Lubricants: MPG - Multipurpose Grease
HO - Hydraulic Oil - ISO-Vg grade 32, 46
GEAR OIL - Good Quality Worm Gear Oil - SAE 90 - AGMA#5 - EP Compounded
CL - Chain Lube. Use a good quality chain lubricant
NOTE:
Recommended lubricating intervals are based on normal use. If machine is subjected to severe operating conditions, such as a high number of cycles, location, corrosive/dirty environment,
etc., user must adjust lubricating requirements accordingly.
31215821
SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
Table 6-4. Lubrication Intervals for Various Components
NO/TYPE
LUBE/METHOD
LUBE POINTS
HO - Check Hyd. Oil
Level
HO - Change Hyd. Oil
— MPG
CL - Brush or Spray
(See Note)
INTERVAL
3 6 1
MONTHS MONTHS YEAR

COMMENTS
2
YEARS
Check fluid level every day.
Change hydraulic oil every 2 years.
NOTE: Prior to checking hydraulic oil level, operate
machine through one complete cycle of lift

function (full up and down). Failure to do so
will result in incorrect oil level reading on the
hydraulic reservoir.
Upper: Permanently Sealed.
Lower: Repack if Serviced.
Inspect, lubricate if dry or rusting.
6-9