Walk-Around Inspection Components - JLG 10MSP Operation And Safety Manual

Walk-Around Inspection Components

Refer to Figure 2-1.
INSPECTION NOTE: On all components, make sure there are
no loose or missing parts, they are securely fastened, and no
visible damage, leaks, or excessive wear exists in addition to
any other criteria mentioned.
1. Front Caster Wheels - Check for any debris stuck to or
around wheels.
2. Base Frame - Check for loose wires or cables dangling
below the base.
3. Batteries (on each side of machine) - Not leaking; bat-
tery cables secure to posts; no corrosion.
4. Rear Drive Wheels - Check for any debris stuck to or
around wheels.
5. Ground Control Station - Main Power Switch (Key)
operable; placards secure and legible; control switches
return to neutral position when activated and
released; emergency stop switch operates properly.
31215821
SECTION 2 - PREPARATION AND INSPECTION
6. Motor/Pump/Reservoir Unit - No evidence of
hydraulic leaks.
7. Manual Descent Control Valve - Refer to Inspection
Note.
8. Platform Control Console - Platform control; placards
secure and legible, control lever and switches return
to neutral position when activated and released;
emergency stop switch reset for operation; control
markings legible.
9. Platform Assembly and Gate - Platform railings;
entry gate in proper working order, closing properly.
10. Remote Manual Descent (If Equipped) - Refer to
Inspection Note.
11. Power Tray (If Equipped) - No evidence of hydraulic
leaks.
2-7