Platform Control Indicator Panel - JLG 800A Operation And Safety Manual

Platform Control Indicator Panel

NOTE: The platform control indicator panel uses different shaped
symbols to alert the operator to different types of opera-
tional situations that could arise. The meaning of those
symbols are explained below.
Indicates a potentially hazardous situation, which
if not corrected, could result in serious injury or
death. This indicator will be red.
Indicates an abnormal operating condition,
which if not corrected, may result in machine
interruption or damage. This indicator will be yel-
low.
Indicates important information regarding the
operating condition, i.e. procedures essential for
safe operation. This indicator will be green with
the exception of the capacity indicator which will
be green or yellow depending upon platform
position.
3121209
SECTION 3 - MACHINE CONTROLS AND INDICATORS
NOTE: For engine starting, the footswitch must be in the released
(up) position. Footswitch must be actuated in order for
controls to function.
NOTE: These machines have a 7 second delay timer. If a function
has not been activated within 7 seconds after depressing
the footswitch, recycle footswitch.
TO AVOID SERIOUS INJURY, DO NOT REMOVE, MODIFY OR DISABLE
THE FOOTSWITCH BY BLOCKING OR ANY OTHER MEANS.
FOOTSWITCH MUST BE ADJUSTED SO THAT FUNCTIONS WILL OPER-
ATE WHEN PEDAL IS APPROXIMATELY AT ITS CENTER OF TRAVEL. IF
SWITCH OPERATES WITHIN LAST 1/4" OF TRAVEL, TOP OR BOTTOM,
IT SHOULD BE ADJUSTED.
1. Footswitch/Enable Indicator
To operate any function, the footswitch must be
depressed and the function selected within seven sec-
onds. The enable indicator shows that the controls are
enabled. If a function is not selected within seven sec-
onds, or if a seven second lapse between ending one
function and beginning the next function, the enable
– JLG Lift –
IMPORTANT
3-13